Randner teamed up

Last week, I received the frame and compo of Landner that I ordered at Bike24. After ordering all, I changed the compo set to another grade, changed the brakes, added lights, etc. by e-mail, but it was good to be able to communicate in appropriate English. A total of 2 boxes of frames and parts.
opening ceremony. It opens at last. It was hard to pack well. First of all, I forgot to install BB and take a picture. W lever mounting. I was worried about using the STI lever, but after all it became the W lever of the diacompe. Crank mounting. First, I installed the crank without installing the SPACER of BB and Scosked, so I started over from the BB installation. I forgot to order the head parts at the same time, so the work on this day is so far. The next day, the head parts arrived and work resumed. As expected, Amazon Prime. Press-fit of head parts. Press-fit end. The lower ball push is also press-fit. I passed through the bearing etc. for the time being. For the time being, temporarily assemble the handle. I chose a landner bar called B135AA in Nitto. When I tried to adjust the saddle position, the seatpost interfered and did not go down, so cut the seatpost. The saddle position is adjusted, and the length of the fork is roughly adjusted and cut. Star Fanglenut was scared if he failed, so I made it a pressure plug. The pipe cutter seems to be slightly raised on the outside of the cutting surface by plastic cutting, and the column spacer of the last size does not enter, so the outside of the cutting surface is flattened with a file and the column spacer enters safely. Attach column spacers, stems, handles, etc. The column spacer was too much… So that the brakes work well even when packed with luggage. The brake caliper personally can not trust one push of Shimano, so I push both of the TRP. Sproke and rear derailleur mounting. Front derailleur mounting. I wanted to adjust the length of the chain, it was just the first length. Connecting pin press-fit. Wiring of brake cable and shift cable, adjustment of front derailleur and rear derailleur is also finished. The winding work of the bar tape which is weakest in character is also finished. Front carrier, rear carrier and end of installation of front bag. I also installed the front light and the rear light. It emits light with electricity generated by the hub dynamo of the front wheel, so you don't have to worry about running out of battery. After this, I went to a bicycle shop in the neighborhood to register for crime prevention. It was dark on the way back, but it was so bright that I didn't need any other lights. I want to go to a bicycle camp.