Installation of roof ventilator and preparation of Tango Peninsula rally

Last weekend I installed a GC8 Impreza roof ventilator Air conditioner-less car was tough in summer, so I won a bid at Yafuoku many years ago, but the installation work was mendoku and I stayed rolling in the room All the time I decided to install it because it was too hot even if I was in a tent at castle rally service the last week, I decided to install this thinking that it was Akan First of all, I stripped off the interior of the roof On Saturday I thought it was difficult to strip off by interfering with the roll bar, but I thought that I would take it more easily and leave time than I thought, but I forgot that I decided on the next day because it was forgetful and I did not want to fail, I thought that I would do it at once from positioning to installation tomorrow, and saturday's work was finished After this, I went to get the Catz to get the necessary hanko to apply for the Tango Peninsula rally I came to Cats, this Civic gray line seems to be a pros and cons
Sunday, I got up about noon because it seems to take time to work, and work starts in hot weather State before work 1 State before work 2 First marking in the place where the hole is drilled After checking again and again, put a spirit and make a hole Further I can not draw after I made a hole hole hole with a hole saw, but after all I roughly shaped it with sander At the end, I shaved with a file, and I did a hard amateur work, and it became like this in the place where I should shave about this Anymore If I thought that I would be tingling something, I rubbed my arm slightly and opened a hole for the bloody stay in total, and then attached the rubber and front and rear stay of the opening I put a rubber washer that seemed to be durable that was written in various places of the previous stay it was heat resistant and took measures against waterproofing Even if I tried to attach the stay behind and try to close it, it does not close properly … The impreza seems to have a reinforced object for ventilator passing to the roof, but there is no such thing in Mirage, Because the stay is attached at an angle that is originally impossible, it seems not to close subtly While impatient, I spread the hole behind and retry I did not close it extra I tried A little more impatiently, this time I feel like I started to close the hole in front, so I will spread the hole a little at a time, fortunately, the range of rubber of the back stay was wide, I spread it while thinking whether the rubber was spreading for such fine adjustment and started to close properly if I spread it and repeated the retry It was good to say in the result, but it came to close properly, so this time it was okay even if it rained, put water in a plastic bottle and hung it from about 6 liters above, I was relieved that there was no water leak somehow, so I tried it lightly because the water leak was okay, so at the moment there is no directivity in the wind, so I think that I will wear a duct and make it comfortable sooner or later Since the work was also completed safely, I completed the application documents for the Tango Peninsula rally with confidence today Some of them were in a common format with All Japan, so there were items that I did not usually need to write, but somehow I was able to put it out to the post office for lunch break I was able to pass it to the post office safely … The rest of the work until the actual production is engine oil replacement ・ Mission oil replacement ・ Car speed pulse Fix It is about this for now If it doesn't break any more, I'll try not to hit it for exactly a month left until the actual performance.